1. First, turn the wire cutting machine computer to the processing page
2. Click "setting", click "HF power", click "ms-wedm", and then click "3 bit type 4"
3.Then click "HF power setting" and you will see the following:
4.Then click "send parameters", first select "No 1", and then click "send parameter 1"
5.The manual control box will show that the speed of the wire is 500, the pulse width is 50, the pulse to pulse is 9, and the power amplifier is 5
6.Then select "No 2" and click "send paramater2" to show that the wire speed is 300, pulse width, pulse width, etc. will change.
7.Then click "send parameter 3" to show that the wire speed is 100, the pulse width is 06, the pulse to pulse is B, and the power amplifier is 2
The premise of this operation is that the wire cutting machine factory settings have not been changed.
